How do you change the donut gasket on a Ford Probe GT?

Difficulty Level: Beginner to Moderate

Estimated Time: 30 minutes

Tools and Materials Needed:

- 10mm socket wrench

- Flathead screwdriver

- Replacement donut gasket

Instructions:

1. Park your Ford Probe GT in a safe location and turn off the engine. Engage the parking brake and chock the wheels to keep the vehicle securely in place.

2. Locate the donut gasket. The donut gasket is located on the underside of the vehicle, between the fuel tank and the fuel filler tube. It is typically a round or oval-shaped gasket made of rubber or cork.

3. Use a 10mm socket wrench to remove the bolts holding the donut gasket in place. There will typically be four or six bolts securing the gasket.

4. Once the bolts are removed, carefully pry the old donut gasket off the fuel tank and the fuel filler tube using a flathead screwdriver. Be careful not to damage the surrounding components.

5. Clean the mating surfaces of the fuel tank and the fuel filler tube to remove any dirt or debris. This will ensure a proper seal for the new gasket.

6. Install the new donut gasket by positioning it between the fuel tank and the fuel filler tube. Make sure the gasket is properly aligned and seated in place.

7. Reinstall the bolts that secure the donut gasket. Tighten the bolts evenly and securely.

8. Start the vehicle and check for any leaks. If there are no leaks, the new donut gasket is installed correctly.

By following these steps, you can successfully change the donut gasket on your Ford Probe GT.