How do you replace the igniter on a Whirlpool gas dryer?

Replacing an igniter on a Whirlpool gas dryer can be a simple and straightforward process. Here are the steps to guide you through the replacement:

1. Disconnect Power: Before starting, ensure that the dryer is unplugged or disconnected from the power source.

2. Remove the Access Panel: Locate the access panel for the dryer igniter. This panel is usually found near the burner tube or flame tube on the back of the dryer. It is usually held in place with screws. Use a screwdriver to remove the screws and take off the access panel.

3. Remove the Old Igniter: Once you access the igniter, remove the screws or fasteners holding it in place. Gently disconnect the wires connected to the igniter. Remove the old igniter from its bracket or mounting.

4. Prepare the New Igniter: Take the new replacement igniter and ensure that it is compatible with your dryer model. Align the new igniter in its bracket or mounting and secure it with the screws or fasteners removed earlier.

5. Connect the Wires: Reconnect the wires disconnected from the old igniter to the new one. Ensure the connections are secure and properly fitted according to the wiring diagram if provided.

6. Reinstall the Access Panel: Place the access panel back in its position. Secure it tightly with the screws you removed earlier.

7. Test the Igniter: Plug in or reconnect the dryer's power source. Turn on the dryer and check if the igniter lights up properly when you select a drying cycle. If the igniter works successfully, your replacement is complete.

Remember, if you are not comfortable working on electrical components, it is always advisable to seek assistance from a qualified appliance repair technician.